Cost-effective & accurate

  • bild werkzeuge diaschaft

Diamond honing shafts

The diamond honing shafts offered by NAGEL provide a low-cost alternative to tools with sticks in the diameter range of 1.2 – 23 mm. The electroplated tools realise a long service life and a good cutting capacity also with hard materials.

Using a corresponding adapter these diamond honing shafts can be used on all common honing, drilling and turning machines.

DHS diamond honing shaft

Standard tool for through bores

SHS diamond honing shafts

Standard tool for blind hole bores

DIK diamond honing shaft

Diamond shaft for the highest requirements regarding accuracy. Equipped with expanding mandrel with cone 1:50. Long cutting layer

FDS diamond honing shaft

Honing shaft fixed to honing diameter without expanding mechanism. Wear compensation is made manually via an expanding mandrel. Easy handling for machining of through bores without need for adapter. Holding, for example, in a chuck.

Adress

NAGEL Maschinen- u. Werkzeugfabrik GmbH
Oberboihinger Straße 60
D-72622 Nürtingen

Phone: +49 7022 / 605-0
Fax: +49 7022 / 605-250
E-Mail: info@nagel.com

Kontaktformular

Please, enter your name
Please, enter your e-mail address Mail address is not not valid
Please, enter your message

Anfahrt

Please publish modules in offcanvas position.