Machines & tools for your industry:

Fairs dates

14.03.2018 - 17.03.2018
GrindTec, Augsburg
28.05.2018 - 01.06.2018
BIEMH, Bilbao, Spanien
10.09.2018 - 15.09.2018
IMTS, Chicago, USA
18.09.2018 - 22.09.2018
AMB, Stuttgart
01.11.2018 - 06.11.2018
Jimtof, Tokio, Japan
24.01.2019 - 30.01.2019
IMTEX Metalcutting, Bangalore, Indien

Superfinishing machines with rotating tools are used for the machining of spherical surfaces and flat surfaces with self-sharpening superfinishing cup wheels or superfinishing sleeves ...


Superfinishing machines SPH, SPHK and SPV

Superfinishing machines with rotating tools are used for the machining of spherical surfaces and flat surfaces with self-sharpening superfinishing cup wheels or superfinishing sleeves.

Typical for flat surface machining is the parallel displacement of tool and workpiece axis and a low speed. In contrast to grinding and fine turning there are no changes to the microstructure in the edge zone through thermal changes to the surface. As high level of overlapping results in a very good correction of the flatness. At the same time the plane parallelism and wobble can be improved. The workpiece and cup wheel counter rotate.

With the machining of spherical surfaces the axes of symmetry and rotation of the tool and workpiece intersect. The very high form correction is achieved by a high level of overlapping. Also here the tool and workpiece rotate in opposite directions.

Ceramic bond diamond and CBN cup wheels and respective finishing sleeves are used as tools. Depending on the workpiece volumes to be machined and the feed of the workpieces, different machine concepts are available with a horizontal and vertical design. On request we also produce customer-specific machines.

The range of workpieces includes the contact surfaces of planet gears and gearwheels, metallic sealing surfaces of components of injection pumps, ball pins and glide shoes of hydraulic construction parts, ball valves, ball pins used in vehicle construction and medical protheses.

Usually abrasives made from ceramic bonded silicon carbide are used for the machining of steel and cast iron. If more cutting capacity is required, for higher circumferential speeds also abrasives made from ceramic bonded special fused alumina can be used. For the same grain size these generate a slightly greater roughness than silicon carbide tools.


Ceramic superfinishing abrasives

Usually abrasives made from ceramic bonded silicon carbide are used for the machining of steel and cast iron. If more cutting capacity is required, for higher circumferential speeds also abrasives made from ceramic bonded special fused alumina can be used. For the same grain size these generate a slightly greater roughness than silicon carbide tools.

Soft and tough materials are machined with special, synthetic bonded fused alumina abrasives containing graphite. Diamond or CBN abrasives are used to machine very hard materials such as carbide, glass, ceramics and others.

 

The following general rules are valid:

  • Surfaces to be machined with a greater roughness require a coarser grain of abrasive
  • Harder materials to be machined require a softer abrasive
  • Surfaces to be machined with a greater roughness require an abrasive which is correspondingly harder

 

Adress

NAGEL Maschinen- u. Werkzeugfabrik GmbH
Oberboihinger Straße 60
D-72622 Nürtingen

Phone: +49 7022 / 605-0
Fax: +49 7022 / 605-250
E-Mail: info@nagel.com

Kontaktformular

Please, enter your name
Please, enter your e-mail address Mail address is not not valid
Please, enter your message

Anfahrt

Please publish modules in offcanvas position.